dmx_basics:dmx_addresses
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| dmx_basics:dmx_addresses [2013/03/12 22:03] – external edit 127.0.0.1 | dmx_basics:dmx_addresses [2022/11/29 21:54] (current) – [DMX Addresses.] djsupport | ||
|---|---|---|---|
| Line 14: | Line 14: | ||
| When the fixtures have received the address 0 synchronizations they count until there address is send and then start to listen.\\ | When the fixtures have received the address 0 synchronizations they count until there address is send and then start to listen.\\ | ||
| Fixture 3 will wait until address 13 comes and it will then listen to the next 6 addresses.\\ | Fixture 3 will wait until address 13 comes and it will then listen to the next 6 addresses.\\ | ||
| - | FreeStyler must be set to control this fixture on the same address so they match.\\ | + | FreeStyler must be set to control this fixture on the same address, so they match.\\ |
| \\ | \\ | ||
| - | The 6 addresses | + | The 6 addresses |
| In the DMX table the channel function will be described from 1 to 6 and as the figure above shows this is an offset definition.\\ | In the DMX table the channel function will be described from 1 to 6 and as the figure above shows this is an offset definition.\\ | ||
| \\ | \\ | ||
| {{: | {{: | ||
| \\ | \\ | ||
| - | If a fixture are using 6 channel then in Fixture Creator the total no. of channels has to be 6.\\ | + | If a fixture are using 6 channel, then in Fixture Creator the total no. of channels has to be 6.\\ |
| - | If the total no. of channel is wrong then the fixture will still be listening on 6 channels and there is a risk mall function.\\ | + | If the total no. of channel is wrong, then the fixture will still be listening on 6 channels and there is a risk mal function.\\ |
| If the number here is set to 5 instead of 6 then “fixture 2”-Strobe and “fixture 3”-Dimmer will react on the same channel and thereby malfunction.\\ | If the number here is set to 5 instead of 6 then “fixture 2”-Strobe and “fixture 3”-Dimmer will react on the same channel and thereby malfunction.\\ | ||
| \\ | \\ | ||
dmx_basics/dmx_addresses.1363125803.txt.gz · Last modified: by 127.0.0.1